Luckfox Pico boards are tiny Linux computers, popular for low-cost vision and edge AI experiments. Chinneo's SC3336 3MP camera module for Luckfox Pico is made for that series. It uses the SC3336 sensor with a 98.3 degree wide-angle M12 lens.
Key specs
Specifications
| Item | Details |
|---|---|
| Sensor | SC3336, 3MP, 2312x1304 |
| Pixel size | 2.45 µm x 2.45 µm pixels, 1/2.8 inch optical format |
| Signal-to-noise ratio | 38dB signal-to-noise ratio |
| Lens | M12 lens, 3.95mm focal length, F2.0, 98.3 degree diagonal field of view, distortion <33% |
| Focus | Manual focus |
| Interface | MIPI camera interface on a 20-pin connector |
| Module size | 24mm x 25mm x 23.95mm |
| Compatibility | Supports Luckfox Pico series boards |
What is in the box
- The Luckfox Pico board shown in the connection illustration is not included
Getting a sharp image
The lens focus is set by hand. Once the camera is in its final position, turn the lens until your subject is sharp, then secure it. The sensor is described as sensitive and low-noise for low-light scenes, which helps indoors.
Questions to settle before you order
- Frame rate, which is not specified.
- The length of the 20PIN connection cable.
See the SC3336 camera page for the full table.
This guide is based on the published specifications for this module. Chinneo has not run hands-on tests of this module.